Videofied Self Powered Wireless KeyPad

The MeerCam Keypad Model CMA 701 is a battery operated, wireless alphanumeric keypad designed for configuring/programming and operating the MeerCam security camera monitoring systems.
 
The MeerCam wireless self powered keypad consists of a liquid-crystal (LCD) display with two 16-character lines, multi-function push buttons, a panic alarm button, a built-in sounder, and S2View® spread spectrum, videofied, interactive, encrypted wireless circuitry for secure two-way communication with the control panel.
 
The LCD display provides easy to read messages and goes out after 30 seconds of no keypad activity, to conserve battery power. Pressing any button (except the panic alarm button) restores the display.
 
The keypad allows complete alphanumeric programming of all system settings/parameters in the MeerCam security systems. S2View® spread spectrum, videofied, interactive, encrypted wireless circuitry effectively makes the keypad a mobile programmer that can be used anywhere within the installation site during system programming. Easy to understand display text guides you through programming, prompting you for simple yes/no or data entry responses. The left and right arrow buttons cycle through menus or values until the desired choice is displayed. Alphabetical entries are done using the 0 - 9 buttons and can be in lowercase, uppercase, or a combination of both. Complete punctuation symbols are also available for data entries such as website/IP addresses and component location naming.
 
Arming/disarming the system with the keypad is easy. For example, the 1 and 2 buttons just below the display can be programmed to arm a specific part of the premises just by pressing the button once, then it will prompt you for your code. The house outline button just below the display can be used to arm the perimeter device of the premises in the same manner.
 
The keypad is typically installed near entry/exit doors to allow system users enough time to arm and exit the premises, and to enter and disarm the system before time delays expire. When the system is armed, the built-in sounder emits a series of exit delay beeps to remind the user to exit before the beeps stop. Upon entering the armed premises, the built-in sounder emits entry delay beeps to remind the user to disarm the system to avoid an alarm. A dual tamper function provides detection for both keypad cover and wall tamper.
 
The keypad is powered by three lithium batteries that can last up to four years or more, depending on the amount of keypad activity. The keypad transmits a check-in signal every eight minutes that includes its unique identification code, along with the tamper condition, serial number, date of manufacture, software revision and battery status. You can install up to three keypads on a system.
 
Electrical Data
  • Power requirements - 3 x 3.6V batteries
  • Battery type - Lithium, LS14500
  • Battery life - Up to 4 years
  • RF technology - S2View® Radio type Spread Spectrum Bidirectional RF
  • Operating frequency - 868/915/920 MHz
  • Transmission security - AES algorithm encryption
  • Supervision - Polled signal every 8 minutes
  • Antenna - Integrated
  • Tamper detection - Wall and cover tampered
  • Display type - Liquid-crystal (LCD)
  • Display size - Two lines, 16 characters each
  • Display backlighting - Automatic
  • Built-in sounder - Emits entry/exit delay beeps, alarms
  • Panic button - One (can be disabled)
  • Operating temperature - 0°/+40°C
  • Maximum relative humidity - 70%, non-condensing
  • Approvals - CE / EN50131 / EN300220 / INCERT/ IDA / NCP (CMA200) FCC (CMA600) A-Tick (CMA700)

Physical Data
  • Material - ABS-ULV0 Magnet Alnico 5
  • Dimensions - 177 mm x 95 mm x 37 mm (LxWxD): 7 in. x 3-3/4 in x 1-1/2 in.
  • Weight - 255 g/ 9 oz. (without batteries)

Installation/Mounting
  • Keypad/Base: One screw secures keypad to base
  • 3 screws secure keypad base to mounting surface.
 
For more detailed equipment specifications on the MeerCam self powered wireless Keypad - download the MeerCam Keypadl specs - HERE 
Purchase or rent the MeerCam Battery Powered Wireless Keypad by contacting Camvista - HERE or TELEPHONE - 0845-2416040
 

Latest News